The Fixed Rack Mount gives you a stable, set-and-forget mounting point for VOLTRA I on a rack upright. Once it’s installed, you’ve got a fixed station you can rely on every session.
Note: The Fixed Rack Mount is sold as a pair, so you’ll receive two mounts when you buy it.
Best for
Home gyms and facilities that want a permanent station
Coaches and clinicians who want repeatable positioning
Anyone who prefers maximum stability over quick height changes
Before you start
Make sure you’ve got the correct bolt type for your rack hole size (the kit supports common rack standards).
Clear a safety zone before installing and training:
At least 83 in (2.1 m) clear on both sides of the mount
In front: VOLTRA I cable length + your movement space + 20 in (0.5 m) buffer
Setup
Assemble the mount
Use the included screwdriver to attach the Mount Base to the Fixed Mount Platform using the bolts.Choose your mounting height
Pick the rack holes that match the anchor height you want most often. If you’re installing both mounts as a pair, choose a matching height on both sides.
Bolt the mount to the rack
Hold the mount flush against the rack upright and line up the rack installation holes.
Insert all bolts with the relevant washers in the correct order and position, before fully tightening any single bolt.
Tighten the bolts using the included wrench until the mount is fully secure and doesn’t rock.
Mount VOLTRA I and do a quick test pull
Attach VOLTRA I to the mount and make sure it’s properly locked before pulling.
Start light and do a smooth test pull. If anything shifts, stop and re-tighten before you go heavier.
Removing the mount
Unload first. Bring resistance down and return the cable to the start.
Unload and remove VOLTRA I first.
Use the wrench to remove the bolts, then take the mount off the rack.
Safety checks
Before you go heavy:
Bolts are fully tightened and the mount doesn’t rock.
The mount is sitting flush on the upright (no angle or gap).
Your rack upright is solid and won’t shift under load.
No one and nothing is inside the safety zone.
Do a light test pull first.
Keep your line of pull clear and the cable path clean.
Safety notes
Indoor use only. Don’t leave the mount outdoors or expose it to rain, sun, water jets, or high humidity.
Keep children away from VOLTRA I and the mount.
Maintain control of the handle or accessory. Sudden release can cause snap-back. Return the cable to the start position before letting go.
Don’t adjust VOLTRA I during a rep. Return the cable to the start position before making any changes.
Don’t train under the influence of alcohol, drugs, medication, or sedatives.
Maintenance
Wipe down with a damp cloth and mild detergent.
Check bolts and hardware periodically. If anything loosens, stop and re-tighten before training.